Is Your Mine Power Center Becoming Rundown and Unreliable?
Has it been out of service for an extended period of time, perhaps stored in less than ideal conditions, exposed to harmful dust, moisture and sunlight? Atlas Electric is here to help. Our rebuild program will extend the life and dependability of each unit, reducing maintenance costs and downtime.
Send us your Mine Power Center and we will give you a no cost preliminary evaluation. Our experienced technicians will examine and test the major components allowing us to give you a cost estimate prior to a commitment from you to proceed.
Our rebuild process will consist of the following:
- Dismantle and remove all components and wiring from the enclosure.
- Clean and sandblast the enclosure inside and out.
- Test, clean and bake the power transformer core and coil.
- Clean and test the surge arrestors, load break switch and fuses.
- Clean and test circuit breakers, ground fault monitors and receptacles.
- Clean and test low voltage transformer, panel and receptacles.
- Clean and test neutral grounding resistor.
- Clean and test lid switches and e-stop.
- Repair or replace components as needed.
- Paint the enclosure inside and out (your choice of color).
- Reassemble and replace all the low and medium voltage wiring.
- Provide new rebuilt electrical drawings.
- 1 year warranty on labor and replacement components.
In addition we can make modifications such as installing main breakers, additional feeder breakers, neutral grounding resistor monitors, meters, ground fault monitor upgrades and arc flash mitigation upgrades.
1000 KVA Mine Power Center
REMANUFACTURED our customers 1000 KVA Mine Power Center including the following:
- Dismantle and remove all components and wiring from the enclosure
- Clean and sandblast the enclosure inside and out
- Increased the height of the enclosure 24” to accommodate new, taller transformer and additional components
- Installed NEW Transformer Core And Coil, Copper wound, 1000 KVA 13800-480Y/277 volt
- Install NEW Cimco Transformer Winding Temperature Monitor and Fan Controller
- Clean, test, and repair or replace as needed all components
- Install RECONDITIONED 1200 amp main circuit breaker
- Install NEW Startco SE105 Ground Fault Ground Check Monitors in isolated control compartment
- Paint the enclosure inside and out
- Install NEW 120 volt UVR’s in existing circuit breakers
- Add additional RECONDITIONED feeder circuit breakers and receptacles
- Reassemble and replace all the low and medium voltage wiring
- Provide new rebuilt electrical drawings
1 year warranty on labor and replacement components.
250 KVA 4160-480/277 volt Mine Power Center
Complete rebuild of customers 250 KVA 4160-480/277 volt Mine Power Center included adding the following new components: 5 KV surge arrestors, Westinghouse main circuit breaker, Pemco 21059 Ground-Fault Ground-Check Monitors, lid safety switches and replacement of all low and medium voltage wiring.
1000 KVA 4160-480/277 volt Mine Power Center
Complete rebuild of customers 1000 KVA 4160-480/277 volt Mine Power Center included adding the following new or reconditioned components: New copper wound transformer core and coil, Westinghouse main circuit breaker, new incoming and feed-thru cable glands, lid safety switches and replacement of all low and medium voltage wiring.